Common problem is the inflatable air inflatable tents, treatment scheme is as follows:

　　

　　1, and leak check points:

　　

　　A, the first column is wiped clean, with soap and water surface, daub to leak check point.

　　

　　Two, find a quiet place (best) in the evening, full of gas, then circle the inflatable tent quietly listen to, will hear the sound of the leak, and then find the root cause.

　　

　　2, dealing with air leakage points:

　　

　　Need to use tools: column fabrics, factory equipped with special glue. Leak point if it is a very small hole, you can use a small piece of gaseous material (the figure jovan any specifications of the inflatable tent in the standard), brushs bit glue, and then stick on the funnelled, after waiting for glue to work, adhesive sealed. If a flat place for gas heat does commissure glue, can divide the following steps:

　　

　　A, first the bonding surface is clean.

　　

　　Second, inflatable tent would give with a bottle of glue, inflatable air column special glue, brush on the pre glue, it must be uniform coating, thickness is appropriate, brush after twice, can glue.

　　

　　Three, the adhesive interface must be designed into a circular or oval shape, try to avoid square and sharp Angle interface shape, lap width not less than 30 mm.

　　

　　Four, after waiting for glue volatilization completely, can undertake bonding, patch should level off, no fold, roller pressure, leveling, use hair dryer to supply heat source at the same time, easy to glue. Adhesive can use inflatable after 6 hours. (note: use glue and gas column is not filling leakage, glue must blow dry rear can glue, time is about 10-20 minutes)

　　

　　When the leak point is very large, more than 15 cm in diameter, you can use the above method first patch, stay when you have free time inflatable tent can be returned to the factory for free repair, to ensure the quality of inflatable tent!

Just visit U-Rides Attraction website:www.U-Rides.com and get in touch today!